Packard 1930 - identification

Queries about model and year identification, engine and vehicle numbers, etc.
Post Reply
vitezslav
Posts: 3
Joined: Mon Mar 02, 2020 11:48 am

Packard 1930 - identification

Post by vitezslav » Mon Mar 02, 2020 12:21 pm

I am from Czech republic and my friend (he is a pensioner not able to speak English) asked me for help with identification of his Packard. There is car photos, available numbers and only one paper document. I will appreciate if anybody will help me with identification and recommendation of books, manuals etc. related to this car.
The original reason, why my friend contacted me was an issue with cooling. Car is working good when the temperature is at around 25°C, but in the real summer (around 30°C) overheating is a problem. He exchanged water pump, radiator was cleaned and he is not sure if this is something normal, or it has to be fixed by some way.

Thank you for any opinion.

Vitezslav
Attachments
DSC02539.JPG
DSC02540.JPG
DSC02548.JPG
P1090664.JPG

User avatar
Ozstatman
Posts: 477
Joined: Tue Jul 21, 2009 12:58 pm
Location: Bowral, Southern Highlands NSW, Australia

Re: Packard 1930 - identification

Post by Ozstatman » Tue Mar 03, 2020 12:17 pm

The engine number *303510* shown in the photo above is in the range for a 1930 Standard Eight (726,733) Packard. Per the Packard Engine Serial Number Reference document on PackardInfo http://www.packardinfo.com/xoops/html/d ... erials.pdf
Mal
Currently - '50 Packard Eight Touring Sedan
Previously - '41 120 Club Coupe(Sold October 2017) & '38 Eight Touring Sedan(Sold July 2009)
Bowral, Southern Highlands, NSW Australia

"Out of chaos comes order" - Nietzsche.

Don Shields
Posts: 118
Joined: Mon Aug 10, 2009 7:33 pm
Location: Philadelphia, PA

Re: Packard 1930 - identification

Post by Don Shields » Tue Mar 03, 2020 7:33 pm

The Beverly Rae Kimes-edited "Packard--A History of the Motor Car and the Company" book shows on page 783 that the engine serial numbers range from 277013 to 305283. So the engine in question fits in towards the end of Standard Eight production. The car should have a wheelbase of 134 1/2 inches (341.63 cm) and will be model number 733. Models 726 and 733 shared the same engine but the 726 was only available as a four door sedan with a wheelbase of 127 1/2 inches. As an open car this one has to be a 1930 Standard Eight Model 733.

Prudence
Posts: 146
Joined: Tue May 28, 2013 1:41 pm

Re: Packard 1930 - identification

Post by Prudence » Wed Mar 04, 2020 10:44 am

Good afternoon...On the left side of the main page...if you scroll down...you will see a little red tool box and 'Tech Tips'. In this area you will find an extensive list of possible 'Overheating Issues'. I found it very helpful when sorting out our 1949 Deluxe 'Miss Princess'...now the old girl runs along happily in any weather that I am happy in...mainly up to about 96 degrees...Have a great Packard day. Ernie in Arizona ;)

GJBINSC
Posts: 119
Joined: Wed Jul 19, 2017 9:31 am

Re: Packard 1930 - identification

Post by GJBINSC » Thu Mar 05, 2020 8:22 am

First I would check the block temp with a infrared temp gun, and try to isolate any temperature hot spots. If the radiator is truly clean, then the next culprit might be the water jacket. On the right side of the engine is the water jacket cover. Removing this is not a big deal, but be careful reinstalling it as the small screws tend to strip easily. New covers and gaskets are available if yours is rotted out on the inside. Cleaning out the water passages would result in more water getting to the rear of the cylinder head where the temp probe is located.

vitezslav
Posts: 3
Joined: Mon Mar 02, 2020 11:48 am

Re: Packard 1930 - identification

Post by vitezslav » Thu Mar 05, 2020 11:33 am

Dear friends,
thank you very much for your answers and recommendations.
Best regards
Vitezslav

wsidejack
Posts: 1
Joined: Tue Jun 02, 2020 8:11 am

Re: Packard 1930 - identification

Post by wsidejack » Tue Jun 02, 2020 9:43 am

Could you possibly take another photo that shows the entire metal plate with the VIN number and such on it? Thanks,

Jack

Post Reply