Dual exhaust

[cp_1247]

Any Eight owners out there that retained their straight 8 but put dual exhaust on it? How was it done, and what did it take parts wise? Looking into this for my project. Thank you

[Adam]

Not too difficult to accomplish. You have a single pipe coming from the exhaust manifold, so you need to connect a 'Y' piece to that and assemble dual systems from that point back. The key decision is where to insert the Y piece. Somewhere behind the rear bumper would be easiest but if you are determined, make it the exhaust front pipe, near the gearbox.

There would be no real advantage, other than twin tailpipes to show off, but if you fancy it, go for it.

[cp_1247]

That was my intent, but I was told by an older gentleman that they used to make a split manifold or split header for packard straight eights. I am assuming it's was completely custom and made from scratch, but was wondering if anyone else has come across this. But yeah, I definitely want the dual look. I figured right after the rear axle, Y it, and send one pipe to each side.